Retsch SM 100 User Manual download pdf (Page 33)

Cleaning and service

Fig. 18: Cutting gap

• By twisting the stud bolts (U) to the right, slide the cutting bar closer to the

rotor blade and thereby reduce the cutting gap. Increase the cutting gap by

twisting to the left [3].

• Tighten the screw (WS) and check the cutting gap. Repeat the process if

necessary.

• After adjusting the cutting bar, tighten the screw (W) firmly again to 7Nm [4].

• Finally re-assemble the right and left-hand cover on the device.

Do not set the cutting gap to less than 0.3 mm. Contact between the cutting plates

and cutting bars can damage the mechanical components.

The tightening torque of the screw (W) must be 7Nm. This is necessary to

guarantee that the cutting bars are securely positioned.

Pos: 8.4 / 00 010 Be dienu ngs anl eitu nge n K apit els amml ung en /SM 100/ 004 0 SM 10 0 War tu ng, R ei nigu ng u nd Vers chl eiß /40 06 SM 10 0 M odul F ilz dic htu ng - War tung un d Austa usch @ 5\ mod_1350892180439_9.doc @ 34930 @ 2 @ 1

6.2 Felt gasket – servicing and replacement

NOTICE

Replace the felt gasket (FD) every three months. (03.182.0024)

Fig. 19: Felt gasket

• Remove the rotor (H).

• Unscrew the two screws (SD).

• Remove the sealing ring (DR) that holds the felt gasket.

SP1

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Comments to this Manuals

No comments

Retsch SM 100 User Manual Page 33

Comments to this Manuals

Related products and manuals for Equipment Retsch SM 100