Retsch AS 200 jet User Manual download pdf (Page 36)

Operating the machine

– The data are sent by the connected PC via interface cable (RS232 or USB)

to the controller PCB. The controller PCB forwards the data on to the boot

loader of the display unit.

5.16.8.4.2 Controller

– The target device controller is selected on the PC via a software update

selection menu.

– The data are sent by the connected PC via interface cable (RS232 or USB)

to the controller PCB. The controller PCB forwards the data on to the boot

loader of the display unit.

5.16.8.5 Sensor calibration

See chapter “pressure sensor calibration”

5.16.9 Service level

NOTE

Access to this menu point is exclusively permitted for service employees or

authorised service personnel.

Pos: 9.51 /0020 Üb erschriften/1 .1 Überschriften/ 1.1 Überschrif ten BDA/11 St arten, Unterbrech en, Stoppen @ 0\mod_12 29417133049 _9.docx @ 5070 @ 3 @ 1

5.17 Starting, Interrupting, Stopping

Pos: 9.52 /0005 RET SCH Bedi enungsanleitung en Kapitelsam mlungen/AS200J et/0007 AS20 0Jet Bedienung/ AS200Jet Modul Starten Stop pen @ 1\ mod_1239194086 237_9.docx @ 8026 @ @ 1

• Switch the device on by pressing the on/off switch at the back.

• Use the operating knob (F) to set the sieving parameters you want.

• Put the test sieve with the sample onto the nozzle compartment.

• Place the lid on the sieve.

NOTE

The sieving will not start if the lid is not on.

• Start sieving by pressing the START button (D).

• You can also start the air jet sieving directly by pressing the QUICK START

key (G). (see chapter on Quick Start key functions)

Pos: 9.53 /0020 Üb erschriften/1 .1 Überschriften/ 1.1 Überschrif ten BDA/11 Quick Start - T astenfunktion @ 1\mod_1240 313233592_9.doc x @ 8229 @ 2 @ 1

Pos: 9.54 /0005 RET SCH Bedi enungsanleitung en Kapitelsam mlungen/AS200J et/0007 AS20 0Jet Bedienung/ AS200Jet Modul Quick Start Ta stenfunktio n @ 1\mod_12 39194087706 _9.docx @ 804 2 @ @ 1

The QUICK START (G) key can be used to start a pre-programmed sieving

process directly without accessing the menu.

Pos: 9.55 /0020 Üb erschriften/1 .1 Überschriften/ 1.1 Überschrif ten BDA/11 St and-by @ 7\ mod_138684112 2969_9.doc x @ 53601 @ 2 @ 1

5.18 Stand-by

Pos: 9.56 /0005 RET SCH Bedi enungsanleitung en Kapitelsam mlungen/AS200J et/0007 AS20 0Jet Bedienung/ AS200jet Mo dul Stand-By-Monitor @ 7\mod_138 6841015177_9. docx @ 53590 @ @ 1

After the device has been inactive for 15 minutes (time after a STOP command),

the stand-by screen switches on automatically.

By pressing one of the buttons or touching the operating button, the stand-by

screen disappears without executing the command given.

If you were in a sub-menu when the stand-by screen was activated, you return

automatically to this selection window.

NOTE

The stand-by screen cannot be deactivated.