Retsch RS 200 User Manual download pdf (Page 21)

15.11.2006  Retsch GmbH 21 Doc. Nr. D 98.725.9998

Setting possibilities via the display menu

For setting possibilities on the display described below please observe the menu structure on this page. The

selection bar in the display should be operated as follows:

 Vertical manoeuvering through the structure by turning the setting knob

 Horizontal manoeuvering through the menu structure by pressing the setting knob

 Setting of numerical values or decisions by turning the setting knob

 Confirmation of settings by pressing the setting knob

 With “RETURN” you go to the previous menu structure level

 By continuous pressing of the setting knob you return to the basic screen

Languages

Display

Languages

You can select the language here. After selection and pressing the setting knob the complete menu structure is

shown in this language.

False language selection

If the wrong language is accidentally selected switch off the unit at the main switch.

Keep the buttons pressed simultaneously and switch on the unit again.

After selecting the correct language switch off the equipment and then immediately on again.

Confirm your selection by pressing the setting knob.

The unit is now set permanently in your language and you are in the main menu.

Manual operation

If this function is set you can call and change all parameters and functions at any time.

This is also possible during milling.

Milling programme

 To get to the „Milling programme“ function press the setting knob with “Manual

operation” set. Milling programme 1 appears, flashing, in the display. Furthermore

data which may already have been stored in Milling programme 1 are also

displayed.

 By turning the setting knob to the right you can select other milling programmes 2-

10. Any parameters which may have been stored are displayed each time.

 You can start the machine directly with the selected milling programme.

 To return to „manual operation“ turn the setting knob completely to the left and

confirm with the setting knob.

Milling time

00:01 bis 99:00

Minutes: Seconds

The RS200 is started with the preselected milling time and the speed last used.

Speed

700 to 1500 rpm

The RS200 is started with the preselected milling time and the preselected speed.

For milling cups with agate lining the speed is limited to

700 rpm and cannot be changed.

The same applies if no milling cup is clamped.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Comments to this Manuals

No comments

Retsch RS 200 User Manual Page 21

Comments to this Manuals

Related products and manuals for Equipment Retsch RS 200