Retsch RS 200 User Manual download pdf (Page 19)

15.11.2006  Retsch GmbH 19 Doc. Nr. D 98.725.9998

If the filling level of the milling set is too high or too low the

milling result will be impaired and damage (wear increase) to

the milling set can result.

Please take necessary measures, depending on the dangerous

nature of your milling material, to avoid danger to persons.

When removing and opening hot milling cups it is essential to

wear protective gloves.

Danger of burning the hands.

Cleaning the milling cups

To clean the milling cups the seal between the lid and milling

cup must be removed.

Milling cups, including those with bonded ceramic inserts,

can be cleaned with alcohol or petrol, or can also be boiled

out briefly.

Do not subject milling cups with ceramic inserts to sudden

temperature variations during rinsing.

The ceramic inserts can crack through sudden

temperature differences.

Drying the milling cups

The milling cups can be dried in a drying oven, at any time

after cleaning, at the temperatures given below.

Milling cup material

Temperature

Special steel

Up to 200°C

Stainless steel

Up to 200°C

Tungsten carbide

Up to 150°C

Agate

Up to 120°C

Zirconium oxide

Up to 120°C

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Retsch RS 200 User Manual Page 19