Retsch RS 200 User Manual download pdf (Page 16)

15.11.2006  Retsch GmbH 16 Doc. Nr. D 98.725.9998

In the RS200 a Retsch milling set of volumes 50 / 100 / 250

ml and materials special steel / agate / tungsten carbide can

be used.

Never start the RS200 without the clamped milling set.

Mechanical components can become damaged.

Preparation of the milling process

 Fit the milling cup with a disc and a ring. Two rings can

also be inserted, depending on the milling set.

Position the rings and disc as shown in the

illustration opposite.

(Fig. 10 Positioning the ring and disc)

 The material to be milled is filled into the space R

between the milling cup wall and the first ring. For an

optimum milling result do not fill any material into the

space between the inner ring and disc.

(Fig. 11 Filling volume of milling cup)

 Remove any residues of the milling material adhering to

the milling cup (e.g. with a brush).

 Close the milling cup with the lid, not forgetting the seal.

 Engage the milling set in the locking bolt B of the holding

device by turning slightly.

(Fig. 12 Locking bolt)

 The milling set is clamped with the eccentric lever S

 You can then close the hood and start the RS200

(Fig. 13 Eccentric lever)

Please take necessary measures, depending on the

dangerous nature of your milling material, to avoid danger

to persons.

Fig. 10 Positioning ring and disc

Abb.7 Bedienfeld

Abb.10 Platzierung Ring und

Scheibe

Abb.7 Bedienfeld

Fig.11 Filling volume of milling cup

Fig. 12 Locking bolt

Fig.13 Eccentric lever

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

No comments

Retsch RS 200 User Manual Page 16