Retsch TG 200 User Manual download pdf (Page 16)

2/25/2013  Retsch GmbH 16 0002

Drying mode

Storage and recalling drying parameters

2 5 8 10 11 13

You can store, change or overwright the drying parameters temp –

air flow – interval and time at any time in the programme

positions P1 to P9.

After switching on the TG200 the indication “on” appears in the

display 2.

By pressing the key PROG the next programme position P1 to P9

can be reached. After programme position P9 on reappears in the

display. In the PROG mode all keys except PROG, START and

STOP are inhibited.

 on = free adjustment of the drying parameters 5/8/10-11

and 13 is possible, or

 P1 to P9 = parameters can be saved and recalled here

 Start = drying process is started with the parameters

stored in programme position P1 to P9.

Allocation of storage location

 Press PROG key until required storage location P1-P9 has

been reached.

 Press SET key – all displays flash

 Set drying parameters 5/8/10-11/13

 Press SET key; values are stored

Flashing of the display stops, the adjustment inhibitor is

activated and sieve parameters are stored. In the PROG

mode all keys except PROG, START and STOP are inhibited.

Signal tone for end of drying process

If the drying process is brought to an end within a definite time

without interruption, the end is signalled by an acoustic signal

tone which is sounded 5 times.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

Retsch TG 200 User Manual Page 16