Retsch AS 400 User Manual download pdf (Page 18)

06.11.2012  Retsch GmbH 18

Memory – saving and calling-up sieve parameters

2 5 8 10 11 13

The memory function, thus saving or calling-up preselected sieve

parameters, is only available in standby mode. You are able to

change and overwrite program places P1 to P9 at any time.

After the AS400 control has been turned on, display 2 shows

"on".

The next program place P1 to P9 is reached by pressing the

PROG key. on reappears in the display after program place P9.

 on = the sieve parameters 5/8/10-11 and 13 can be

freely set here.

 P1 to P9 = sieve parameters can be stored and called-

up here

 Start = sieving process is started with the sieve parame-

ters stored in program place P1 to P9.

Occupying storage space

 Press the PROG key until the required storage place P1-

P9 has been reached.

 Press the SET key, all displays flash

 Set sieve parameter 5/8/10-11/13

Programming mode can be aborted by repressing the PROG key,

values are not saved

 Press the SET key, the values are saved

The displays stop flashing, the adjustment lock is activated, the

sieve parameters are stored.

If the AS400 control is actuated with a PC and the

"EasySieve

" sieve software, display 2 shows "ES". No manual

changes to the sieve parameters are possible in this mode be-

cause the values are taken from the software program.

Signal tone for the end of sieving

11 15 16

If the sieving process runs to the end without interruption, the end

is then signalled by a tone sounding 5 times.

Disabling the signal tone :

 Press keys 11 and 16 simultaneously

confirmed by a signal.

Enabling the signal tone :

 Press keys 11 and 15 simultaneously

confirmed by a signal.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

No comments

Retsch AS 400 User Manual Page 18